Results 1 to 10 of 24
-
04-26-2012, 12:02 PM #1
PWE question
Ive never really shipped PWE before. I do have a lot of very low end autos and numbered stuff (nothing thick of course) and was going to buy a book of stamps so I can start moving this stuff. My question is, how many stamps is good on 1 card shipped in a top loader?
-
-
04-26-2012, 12:03 PM #2
1 single card in a toploader usually weighs between 0.7-0.9 ounces, which is just one stamp.
-
04-26-2012, 12:04 PM #3
I think 1 should do it unless it is a thicker Gu then I'd say 2
-
-
04-26-2012, 12:04 PM #4
right on, thanks guys!
-
04-26-2012, 12:04 PM #5
1 Stamp normally suffices. However, some stations (sending or receiving) will tack on a non-machinable charge of .20. If that's the case, it will be returned to sender for additional postage.
-
-
04-26-2012, 12:05 PM #6
would using 2 stamps eliminate that problem you think?
-
04-26-2012, 12:07 PM #7
Yes...but I would just send 1 and take the chance as most stations do not charge this fee. I have only been charged once (sending to Rhode Island) in three years.
-
-
04-26-2012, 12:08 PM #8
Yeah I always only ever use one too, never had a problem.
-
04-26-2012, 12:09 PM #9
nice... well guys i appreciate how helpful you all are!
-
04-26-2012, 12:45 PM #10
Due To Rules Violations
It's .64 to mail non machine for 2 cards in 2 top loaders or under, 1 card is still the same .64
-