Results 1 to 6 of 6
-
11-06-2009, 09:45 PM #1
Can you remove slabbed cards?
I just got my card back from the graders, graded at a 10, but I'm extremely ****** because there is dust, and plastic sliver in the slab, on top of the card. I don't wanna send these jokers my card back, I'd rather get it out and send it to someone else. Any suggestions?
-
-
11-06-2009, 10:00 PM #2
i have cracked a few out i use a hammer and a flat head screwdriver on the top where the grade is tap the case not to hard but hard enough to crack the case once you get the case cracked put the screwdriver in the crack twist it abit till the top lets go then pry it apart then it should be all good if something happens with the card do not blame me if you have a cheaper card i would try it on that one first
-
11-07-2009, 05:13 AM #3Assistant General Manager
You can get it out without a problem. My question is who did you send it too. As if it a 10 from a reputable grader I leave it.
DonCard Supplies
Toploaders 60 point $4, 100 point $7, 140 point $4, 190 point $3, 240 point $3
Soft Sleeves Standard $1 and Thick $1.50
TOP-LOADER 3X4,100 CT PENNY SLEEVES INCLUDED $11
-
-
11-07-2009, 09:00 AM #4
Dremel. Cracked three with no problem. Only thing is the plastic starts to melt... you have to be careful.
-
11-07-2009, 02:23 PM #5
Thanks guys, I got it out without a problem. I sent it to rga. I have since found out that they are not very reputable, and I am just glad I actually got my card back.
This was the first card I have ever had graded, and my loss of money will just go down as a lesson learned. I'm sending it to beckett now, hopefully I'll get a decent grade.
-
-
11-08-2009, 01:53 PM #6Assistant General Manager
Glad to hear but be prepared for less than a 10.
Don
-
Originally Posted by MordeKyle 
